Storm and flood mold usually follows roof leaks, wind-driven rain or water entering from outside. Drying quickly matters, because EPA says water-damaged areas should be dried within 24 to 48 hours. Call the number on this page to be connected with a local mold company in Fort Worth.

Why storms lead to mold here
North Texas gets severe spring storms, hail that damages roofs, and flash flooding along creeks and low-water crossings. Roof damage lets rain into attics and walls, while flooding pushes water into slab-on-grade homes at floor level. Expansive clay soils can also hold moisture against foundations after heavy rain.
Safety before cleanup
The National Weather Service warns that it is never safe to drive or walk into flood waters, and that about 12 inches of moving water can carry away most cars. Stay out of standing water until the area is safe, and have power and gas checked before re-entering a flooded home. Floodwater can carry contamination, so porous items it touched are often discarded rather than cleaned.
What the work involves
- Stop further water entry, such as tarping a damaged roof.
- Remove standing water and dry the structure.
- Tear out saturated drywall, insulation and flooring that cannot dry in time.
- Remediate visible mold under containment, following the written protocol and work plan.
- Arrange a post-remediation check by a different assessor.
Many Fort Worth homes have brick veneer over a slab, so water that gets in through a window, door or garage often wicks into the lower wall cavity and stays hidden for days. A moisture meter or thermal camera can show how far it traveled before anything is torn out.
Roof leaks that reach the attic are covered under attic mold removal, and wall cavities under mold in walls.
Texas requirements
TDLR says a mold remediation or assessment license is required to provide those services, except for visible mold under 25 contiguous square feet. Flooded homes usually exceed that. Verify any company with TDLR's license search, and ask for the Consumer Mold Information Sheet before work starts. Your insurance policy terms are between you and your insurer, so ask them about coverage before tearing out materials, and take photos first.
What it costs
National figures put mold remediation at $15 to $30 per square foot across project sizes, and $1,125 to $3,345 per job overall, while a Fort Worth cost guide gives $1,500 to $6,000 per job. Flood jobs can run higher when water mitigation and rebuilding are added, and these are published estimates rather than quotes. Compare with leak and burst pipe mold removal.

Storm & Flood Mold Removal questions from Fort Worth homeowners
How soon should I start drying after a flood?
Is it safe to go into a flooded home?
Does my homeowner's insurance cover flood mold?
Can I clean up flood mold myself?
Related mold services in Fort Worth
Helpful guides
Storm & Flood Mold Removal in nearby cities and towns
Tarrant County
Dallas County
Denton County
Johnson County
Parker County
Ellis County
Wise County
Hood County
Sources
Last updated: