Mold remediation referrals for Fort Worth & nearby townsCall: (817) 518-2276
(817) 518-2276

Mold in Walls in Fort Worth, TX

moldremediationfortworth.net

Hidden growth behind drywall usually means a moisture source nobody has found yet.

Think mold is hiding behind a wall?
Call now to be connected with a local mold remediation company in Fort Worth.
(817) 518-2276

Mold behind drywall often shows up as a musty smell, stains or bubbling paint before anything is visible. The wall has to be opened and the moisture source fixed, and larger areas call for a remediation company holding a TDLR mold license. Call the number on this page to be connected with a local mold company in Fort Worth.

Peeling paint and mold spots below a window, mold in walls in Fort Worth, TX

How mold gets into Fort Worth walls

Most wall mold starts with a leak or a humidity problem that has gone unnoticed. Common causes include a slow plumbing leak, a failed window seal, a roof or flashing leak running down inside the wall, sweating supply lines and a burst pipe after one of North Texas's occasional hard freezes. Brick veneer homes on slab foundations can hold water behind the cladding, and expansive clay soil that shifts the foundation can open cracks for moisture to enter.

Clues that something is inside the wall

  • A persistent musty odor with no visible source
  • Peeling or bubbling paint, or soft drywall
  • Discoloration near baseboards, outlets or window corners
  • A moisture meter reading that stays high after the surface dries

What happens during the work

An assessor can use moisture readings and, where warranted, sampling to map how far the problem goes. EPA says that if visible mold is present, sampling is usually unnecessary, so a visual and moisture-based assessment is often enough. Remediation then typically means containing the area, cutting out and discarding affected drywall and insulation, cleaning or drying framing, and repairing the leak before any rebuild. Rebuilding drywall and paint is usually a separate trade from the remediation itself. If the source was a burst pipe, see water damage mold.

Cost and licensing

A Fort Worth cost guide lists mold remediation at $9 to $18 per square foot of affected area, and another Fort Worth page gives $1,500 to $6,000 for a typical whole job. These are published estimates, not quotes, and wall work that involves plumbing repair or rebuilding adds cost beyond remediation.

Texas requires a mold remediation license for projects over 25 contiguous square feet, and a license holder must give the property owner the Consumer Mold Information Sheet before work begins. TDLR also says the same person generally cannot assess and remediate the same project, so expect two separate companies. A mold testing visit or a full mold inspection can come first. Verify any company on the TDLR license search.

Renters should know that Texas Property Code 92.052 sets a landlord's repair duty for conditions affecting health or safety once notice is given, so tell the landlord in writing.

Because wall cavities are closed, guessing is risky: opening the wrong spot misses the problem, and opening too much makes a bigger repair than needed. Ask any company how it will limit the opening and protect the rest of the home from dust.

Call now to be connected with a local mold remediation company in Fort Worth.
(817) 518-2276
Wall opened up to studs after mold removal, mold in walls in Fort Worth, TX

Mold in Walls questions from Fort Worth homeowners

How can I tell if there is mold inside a wall?
Look for musty smells, stains, bubbling paint or soft drywall, then confirm with moisture readings. A small inspection hole or a moisture meter can show hidden dampness without opening much of the wall.
Do I have to tear out the whole wall?
Usually not. Remediation commonly removes only the affected drywall and insulation, with the opening sized to the growth and the moisture. The assessor's protocol should spell out how much comes out.
Can I paint over mold on a wall?
Painting over it does not remove the growth or the moisture feeding it, and it can mask the problem. Find and fix the moisture source, then have the growth properly removed.
Who tells me the job is finished?
Texas requires a post-remediation assessment by a consultant who did not write the original protocol. After a successful result, the license holder gives the owner a Certificate of Mold Damage Remediation.

Related mold services in Fort Worth

Mold in Walls in nearby cities and towns

Tarrant County

Dallas County

Denton County

Johnson County

Parker County

Ellis County

Wise County

Hood County

Call now to be connected with a local mold remediation company in Fort Worth.
(817) 518-2276

Last updated:

☎ Call (817) 518-2276